Wiring

Conventional Systems

Alternate wiring (for conventional systems)

If labels do not match terminals, connect wires as shown below.

WIRING NOTES:

  1. If you must connect both R and Rc wires, set the R Slider Tab to the down position (2 wires).

  2. If your old thermostat had both R and Rh wires, set the R Slider Tab to the down position (2 wires). Then connect the R wire to the Rc terminal, and the Rh wire to the R terminal.

  3. If your old thermostat had only one C or C1 wire, connect it to the C terminal. If your old thermostat had two C or C1 wires, call support for assistance.

Heat Pump

WIRING NOTES:

  1. Match each labeled wire with same letter on new thermostat.

  2. Insert the wires into the matching terminal.

NOTE: If you have difficulty inserting wires, you may have to press down the terminal push button next to the corresponding terminal. If the labels do not match the letters on the thermostat, see the diagram above.

Alternate wiring (for heat pumps only)

WIRING NOTES:

  1. Keep R Slider Tab in the up position (1 wire).

  2. If your old thermostat had both V and VR wires, stop now and contact a qualified contractor for help.

  3. If your old thermostat had separate O and B wires, attach the B wire to the C terminal. If another wire is attached to the C terminal, stop now and contact contact a qualified contractor for help.

  4. If your old thermostat had Y1, W1 and W2 wires, stop now and contact a qualified contractor for help

IMPORTANT: Do NOT use W for heat pump applications. Auxiliary heat must wire to AUX or E.